This listing is for 1 personalized white glass jewelry holder. These are made to order. You can also choose to put a name, initial or heart. When you place your order for your white glass jewelry holder, please include the following: Initials/Letters Font of your initials or name Color IF YOU WOULD LIKE THE FONT IN THE PICTURE, PLEASE LEAVE INSTRUCTIONS IN THE "NOTE TO SELLER" SECTION. Thank you for stopping in and come see me again. I'm just getting started, but I have many more designs to come. PLEASE MAKE SURE TO HANDWASH THESE GLASSES. DO NOT PUT IN THE DISHWASHER. INSTRUCTIONS IRON ON VINYL With a hot iron (mine is a little down from cotton so not the max hottest setting) Iron through the plastic. Hold for a few seconds still and then wiggle and then move positions until you've hit all the vinyl. Gently pull on an edge and if the vinyl comes up with it, iron some more. This step takes the longest especially if you have a large image. Next, I like to flip it over and iron a little from the back. Once you are sure the vinyl is securely attached, pull away the plastic. Feel around the vinyl especially at the edges to see if there are any spots that need reinforcement. **MAKE SURE TO WAIT 24 HOURS BEFORE FIRST WASH** VINYL/GLITTER DECALS Press firmly on the transfer tape. Peel the transfer tape back at a sharp angle. At this point, the vinyl should be attached to the transfer tape. If not, please repeat this step. Place the decal on your cup/project and swipe firmly over the transfer tape with a credit card. The decal should be sticking to your cup/project. You may have to work back and forth a couple of times. Be careful when you pull the transfer tape off the vinyl so you do not tear the decal. REMINDER: If you place vinyl on a cup or glass, please hand wash. Please do not place in a dishwasher or submerge in water.