All shelves are made to order and come with pre-drilled shelf support batons, screws and wall plugs. Shelves are priced individually. We also sell gallows brackets that can be used with these shelves. These brackets allow the shelves to be supported from the back wall. If your shelf is over 1.2m wide we recommend using a gallows bracket to add support. Please select a width and depth range from the drop-down options, then personalise with your exact measurements. If, for example, you wanted a shelf that was 470mm wide and 624mm deep, you would select in width [ 450mm - 500mm] and in depth [ 600 - 650mm] then in your order notes you would specify your exact measurements. *This is very important as we will be unable to proceed with your order until we make contact with you to confirm exact measurements* If your specific measurements are not listed, please do message us as we are happy to try and accommodate any size. FAQ’s; Q: I have stud walls, are these shelves suitable? A: The screws and wall plugs we provide are suitable for drywall but for added strength we recommend using gripfill on the support batons when fitting. Q: My walls are uneven, what size should I order? A: The support batons are each 20mm thick, which would allow you to order to your smallest width if the discrepancy was a few mm. If there is a significant disproportion, the carpenter can make the shelves to fit these measurements. For this we ask you order to your largest measurement and specify measurements in the personalisation (eg; 915mm at the front 935mm at the back) or if you are unsure please do message. Q: I’ve measured my space, should I order to the exact size? A: We recommend taking off 5mm from your width. This allows for any discrepancies in the wall and makes fitting easier.